MagJig is constructed to fit perfectly into  a 3/4" board such that the bottom of the magnet is flush to the table surface.  Simply determine an ideal location in you jig fixture that ensures complete contact between the MagJig and the steel table surface.  Drill a through hole and drop the MagJig into the jig fixture.  For permanent mounting, simply affix the MagJig to your board using stainless steel screws (for maximum strength).  MagJigs contain extremely powerful magnets.  Do not turn on unless in contact with a steel surface.  Turning the magnets on without being in contact with steel can be harmful to sensitive electronic equipment and potential cause pinched fingers or skin.  MagJigs work ideally on steel surfaces that are thicker than .25".

Key Benefits

	Fast Setup & Securing
	Uses standard 3/4" material.
	Ideal for jig placement flexibility
	Strong Hold! Strong against shear force.
	Easy On/Off - rotate 1/2 Turn On - reverse & turn Off
	Uses Standard 30 mm Forstner drill for mounting
	Use in multiple Jigs, switch in and out of fixtures with ease.
	Up to 95 lbs of break away force - Do not use for lifting.

Click Here To See MagJig Sample Applications

20 mm MagJig Cut Away

MagJig is constructed to fit perfectly into  a 3/4" board such that the bottom of the magnet is flush to the table surface.  Simply determine an ideal location in you jig fixture that ensures complete contact between the MagJig and the steel table surface.  Drill a 30 mm hole and drop the MagJig into the jig fixture.  For permanent mounting, simply affix the MagJig to your board using stainless steel screws (for maximum strength).  MagJigs contain extremely powerful magnets.  Do not turn on unless in contact with a steel surface.  Turning the magnets on without being in contact with steel can be harmful to sensitive electronic equipment and potential cause pinched fingers or skin. MagJigs work ideally on steel surfaces that are thicker than .25".  Use Multiple MagJigs when greater hold force is required.

Key Benefits

• Fast Setup & Securing
• Uses standard 3/4" material.
• Strong Hold! Strong against shear force.
• Easy On/Off - rotate 1/2 turn On - reverse & turn off
• Uses Standard 30 mm Forstner drill for mounting
• Use in multiple Jigs, switch in and out of fixtures with ease.
• Up to 95 lbs of break away force - Do not use for lifting.
• Ideal for jig placement flexibility

Click Here To See MagJig Sample Applications

MagJig is constructed to fit perfectly into  a 3/4" board such that the bottom of the magnet is flush to the table surface.  Simply determine an ideal location in you jig fixture that ensures complete contact between the MagJig and the steel table surface.  Drill a 40 mm hole and drop the MagJig into the jig fixture.  For permanent mounting, simply affix the MagJig to your board using stainless steel screws (for maximum strength).  MagJigs contain extremely powerful magnets.  Do not turn on unless in contact with a steel surface.  Turning the magnets on without being in contact with steel can be harmful to sensitive electronic equipment and potential cause pinched fingers or skin. MagJigs work ideally on steel surfaces that are thicker than .25".  Use Multiple MagJigs when greater hold force is required.

Key Benefits

Click Here To See MagJig Sample Applications